User Manual

14
MANUAL & WRITE in Manual mode: MIDI Channel Select mode.
Press these two buttons simultaneously while the preamp is in Manual mode to
activate MIDI Channel Select mode. This mode lets you determine the desired
MIDI channel for the currently active bank. The display shows ch. (short for
channel) briefly and then the MIDI channel, for example c01 or onl for OMNI. Off
tells you that the reception of MIDI data is deactivated for the respective bank.
Set the desired MIDI channel using the UP or DOWN buttons. If the display flashes
for one or several channels, this means that the given channel has already been
assigned to the other bank. If a bank is set to OMNI, all MIDI channels are locked
for the other bank. In this case, the other bank can only be set to Off.
After you have selected the desired MIDI channel, store it by pressing the Write
button.
Again, be sure to hold the Write button down until the display reads 000 to
indicate Manual mode and the display no longer flashes. Otherwise, the Write
operation will be canceled before the channel setting is stored.
Press the MANUAL button to quit MIDI Channel Select mode without storing a
channel.
If no other function is activated, the system will quit MIDI Channel Select mode
automatically after about 12 seconds.
DOWN & UP in Manual mode: Volume Controller Setup mode.
Press these two buttons simultaneously while the preamp is in Manual mode to
activate Volume Controller Setup mode. This mode lets you set up the preamp so
you can control the Master level remotely via a MIDI volume pedal. Once you
have pressed the two buttons simultaneously, the display will read Vol for about
two seconds. Then it will indicate the current status, which will be either On or
Off.
You can quit Volume Setup mode without changing its status by pressing the
Manual button (for example, if you just want to view the current status). Use the
UP or DOWN buttons to change the status from On to Off and vice versa. Press
the Write button to store the new setting. Again, be sure to hold the Write
button down until the display reads 000 to indicate Manual mode and the display
no longer flashes. Otherwise, the write operation will be canceled before the
setting is stored.
If no other function is activated, the system will quit Volume Controller Setup
mode automatically after about 12 seconds
MANUAL & WRITE while a preset is activated: Switching to a shadow preset.
Press these two buttons simultaneously while a MIDI preset is active for
approximately three seconds and the preamp will switch to the shadow preset of
that MIDI preset.
The shadow preset contains this MIDI preset's settings as they were before you
edited them or copied another configuration to this memory slot. You can quit
the shadow preset at any time by pressing the Manual button.
The contents of the shadow preset and the contents of the MIDI preset are
swapped when you press the Write button. This means that the old (overwritten)
setting is dumped back to the MIDI preset and the current (new) setting of the
MIDI preset is dumped to the shadow preset. Shadow and MIDI presets can only
be swapped if the given preset is not locked. Again, be sure to hold the Write
button down until the display indicates the MIDI preset number and the three
decimal points no longer flash. Otherwise, the write operation will be canceled.