Installation Instructions

TK 61990-11-IS
©2021 Trane Technologies
3
Important Information
Before starting the installation, be aware of the following requirements:
1. The Thermo King wireless sensors advertise information via Bluetooth low energy. It is
required to have a Thermo King telematics device (i.e TK BlueBox) which will receive the
information.
2. Make sure that the vehicle is active in TracKing before installing the sensor.
3. Make sure that the application version is TK Technician Alpha Release V13.apk or above.
4. Make sure that the TK BlueBox firmware version is M-F205 or above. There is no limitation
on unit software version.
5. The installer needs to have the TK Technician application and credentials to add tractor ID
sensor to the customer account.
NNoottee:: Make sure that the TK Activate application is removed from the phone before using the
TK Technician application.
6. To activate the tractor ID sensor, the installer does not have to be beside the vehicle (The
tractor id sensor is not linked to a particular BlueBox).
7. Installer must be near to the BlueBox to activate the temperature and door sensor
(communication happens via Bluetooth).
NNoottee:: Make sure that the BlueBox is powered (LEDs on).