Specifications

2.3 On-board WAN Setup
The On-board WAN Setup page allows administrator to configure WAN network interface for IP PBX.
Select System -> On-board WAN Setup, and the current setting of WAN network interface is
displayed, e.g. type, IP address etc. Unless the LAN Only is selected, you can choose one of the three
options, Static IP, DHCP, and PPPoE from the Type list for your configuration. Select LAN Only check
box to disable WAN, and only default router and DNS settings are applicable. Select MAC Clone to
change the WAN MAC address.
2.3.1 Static IP
You can click Static IP in the Type list, and manually configure the following information:
․ IP Address
․ Netmask
․ Default gateway IP address
․ Primary, secondary or third DNS servers
Click APPLY to submit.
2.3.2 DHCP
Simply click DHCP in the Type list, and click APPLY. The acquired IP address, netmask, and default
gateway information will show when revisit this page later.
2.3.3 PPPoE
1. Click PPPoE in the Type list.
2. Enter a user name and its password in User Name and Password boxes.
3. Click APPLY.
The PPPoE dialing will start right away. When there is an active connection, the page will show the
acquired IP address, network mask, and default gateway information.
2.3.4 LAN Only
Select LAN Only to disable WAN IP settings but allow the configuration of default gateway and
primary/secondary/third DNS servers.
5