Operation Manual

Hardware Installation
1. Ensure that the computer in use has an Ethernet Controller port (RJ-45 Ethernet Port). For more information, verify with your
computer’s user manual.
2. Connect one end of the Category 5e Ethernet cable into the RJ-45 port of the Access Point and the other end to the RJ-45
port of the computer. Ensure that the cable is securely connected to both the Access Point and the computer.
3. Connect the Power Adapter DC connector to the DC-IN port of the Access Point and the Power Adapter to an available
electrical outlet. Once both connections are secure, verify the following:
a) Ensure that the
POWER
light is on (it will be
orange
).
b) Ensure that the 2.4 GHz/5 GHz WLAN light is on (it will be
blue
for 2.4G, and
green
for 5G).
c) Ensure that the LAN (Computer/ Access Point Connection) light is on (it will be
blue
).
d) Once all three lights are on, proceed to set up the Access Point using the computer.