Installation Instructions

Quick Installation Guide

EnGenius Europe | Veldzigt 28, 3454 PW De Meern,

Netherlands | 0900-WIFIABC | www.wiabc.com

Disclaimer: Information may be subject to changes without prior notication.

https://www.linkedin.com/company/engeniuseurope

https://plus.google.com/+EngeniusEuropeBVDeMeern

https://www.youtube.com/user/engeniuseuropebv

https://twitter.com/engeniuseu

EWS310AP

Stand-alone access point installation

Connecting the access point

Step 1: Connect one end of the Ethernet cable into the LAN port of the access

point and the other end to the Ethernet port on the computer.

Step 2: Connect the power adapter to the DC-IN port of the access point and

plug the other end in to an electrical outlet.

Note: The access point supports both IEEE802.3at PoE (Power-over-Ethernet) or

the included power adapter. You may use either one as the power source.

DO NOT use both at the same time.

IP address configuration

Step 1: Once your computer is on, ensure that your TCP/IP is set to ‘On’ or

‘Enabled’. Open ‘Network Connections’ and then click ‘Local Area

Connection’. Select ‘Internet Protocol Version’ (TCP/IPv4).

Step 2: If your computer is already on a network, ensure that you have set it

to a static IP adress on the interface. (Example 192.168.1.10 and the subnet

mask address as 255.255.255.0)

Access point setup

Step 1: Open a web browser on your computer. In the address bar of the web

browser, typ in 192.168.1.1 and hit Enter.

Step 2: A login screen will appear. By default, the username of the access point

is admin and the password is admin. Enter the current username and

password of the access point and then click ‘Login’.

Step 3: The EnGenius access point user interface will appear. This device can

operate in the following modes: Access point, WDS AP and WDS bridge.

Switch modes by selecting the operation mode under ‘Network’, ‘Wireless’ tab.