User`s manual

Troubleshooting
Cannot access the Internet after successfully setup
ERB9250 with your router
After you set up ERB9250 with your router successfully, moved the ERB 9250 to the center
of your home or office, and found that you could not surf Internet Web pages with your
laptop even though the signal is strong, potentially your router and ERB9250 might be on
different subnets. Check your router’s IP address. If your router’s IP is not 192.168.1.x,
change either your router’s IP address or the ERB9250’s IP address to place them on the
same subnet. Please see the following instruction on how to change your ERB9250 IP
address.
If you own EnGenius ESR9752, ESR9753, or ESR9850 Routers whose default IP address
of 192.168.0.1 is on a different subnet than the ERB9250, you can change ERB9250’s IP
address using the Web-based configuration page.
1. Select Network, and click LAN.
2. In the IP Address field, type 192.168.0.x where x is a number from 0 to 254 except 1.
The last value, designated as x should be unique to each device on the same subnet. Do
not use 1 as the last value, since EnGenius Routers use 1 as the last octet in their IP
address.
3. Click Apply. The router and ERB9250 are now on the same subnet. Associate your
router and connect the ERB9250 with your router again. You should now be able to
access Internet.