User manual

WPS Configuration

1. Enable WPS on your router and ensure it is activated (some routers may require you to

press a WPS button and hold it down for a few second to enable WPS).

2. Press the WPS button on the front panel of your ERB9250 Range Extender once. The

orange LAN LED ( ) will begin blinking.

Note:

• It takes up to 60 seconds for ERB9250 to clone your router. Once the orange LAN

LED stops blinking and stays ON, the setup is complete.

• If the orange LAN LED does not stay ON, the configuration was not successful. In

this case:

⇒ Move the Range Extender closer to your router.

⇒ Ensure the antennas are connected securely to the Range Extender rear

panel.

⇒ Repeat steps 1 and 2.

⇒ Alternatively, consider Quick Manual Configuration if WPS configuration is not

functioning properly.

This completes the WPS setup for your ERB9250 Range Extender. Please proceed to

“Placing Your Range Extender in an Optimal Location”.