User guide

BASIC NETWORK SETTINGS ADVANCED SETTINGS
6-16
6.1.3 Advanced Settings
Define the advanced settings available on the ERB300H/ERB150H.
WARNING!
Incorrectly changing these settings may cause the device to stop functioning. Do not modify the settings in this section without a
thorough understanding of the parameters.
Note:
This section applies to Client Bridge mode.
Fragment Threshold Enter the maximum size of a packet during data
transmission. A value too low could lead to low performance.
RTS Threshold Enter the RTS threshold. If the packet size is smaller than the
RTS threshold, the ERB300H/ERB150H does not use RTS/CTS to send the data
packet.
Tx Power Select the wireless signal strength level. Valid values are between 25%
and 100%.
Click Apply to save the settings or Cancel to discard changes.
!