User guide

INSTALLATION SETUP WIZARD USING THE ERB300H/ERB150H AS A MEDIA ENTERTAINMENT BRIDGE
4-4
Note:
When the ERB300H/ERB150H connects via Wi-Fi to a
remote router under bridge or repeater mode, the
device’s IP address changes to the router’s DHCP subnet
address. However, it is not possible to access the device
using the subnet IP address nor can a static IP address
be assigned in the traditional manner.
A work-around is available by following one of these two
procedures:
 Enter the model name of the device in a web browser’s
address bar. For example, enter http://erb300h/ to con-
nect to the ERB300H or http://erb150h/ to connect to
the ERB150H.
 The default management IP address of the device is
192.168.1.250. To connect to the device over a LAN,
the LAN’s subnet IP address must be 192.168.1.xxx.
Otherwise directly connect a PC to the device.
Manually configure a PC’s IP address to 192.168.1.xxx
and enter 192.168.1.250 in a web browser’s address
bar.
Using the ERB300H/ERB150H as
a Media Entertainment Bridge
Getting Started
Create a wireless media entertainment network using the
ERB300 as a Media Entertainment Bridge (Client Bridge mode)
by following the instructions in the next section.
Setting Up the Media Bridge
Connect the ERB300H/ERB150H to an existing wireless net-
work either by WPS configuration or by Smart Wizard configu-
ration.
Note:
It is recommended to use WPS configuration if the
ERB300H/ERB150H supports it.
WPS Configuration
Note:
See WPS Configuration on page 4-1 for details.