User manual

59
to connect with or enter SSID manually.
Step3 Configure VLAN ID in your wireless device if available.
Step4 Select correct authentication type and password.
Auction: EOC5510’s Access Point Mode does not provide DHCP server so the Wireless Client IP address must configure
manually at the same subnet in Local Area Network.
9.2 Client Bridge Mode
Client Bridge Mode functions like a wireless dongle. It must connect to an Access Point/AP Router to
join the network.
Please refer to the last section to check Access point’s configuration.
Client Bridge
Step1 Login to the web-based configuration interface with default IP 192.168.1.1
Step2 Select your country or region’s regulation.
Step3 Select Operation Mode to Client Bridge from System Properties.
Step4 802.11a (5GHz) wireless network.
Step5 Use site survey to scan Access Points that are available in nearby area.
Step6 Select the AP you would like to associate with.
Step7 Setup the authentication settings that match to the Access Point’s setting.
Step8 Press Apply to process all the configurations.
Auction: Client Bridge’s IP setting must match to the Access Point’s subnet.
9.3 WDS Bridge Mode
Use this feature to link multiple APs in a network. All clients associated with any APs can
communicate each other like an ad-hoc mode.