User manual

41
9 Network Configuration Example
This chapter describes the role of the EOA7530 with three different modes. The Access Point mode’s
default configuration is a central unit of the wireless network or as a root device of the wired
environment. Repeater mode and Mesh network mode need future configuration.
9.1 Access Point Mode + Client Bridge Mode
Access Point
Step1 Login to the web-based configuration interface with default IP 192.168.1.2
Step2 Select 802.11b/g mixed and/or 802.11a as your wireless mode.
Step3 Use AP Scan to scan channels that have been used in nearby area.
Step4 Select channel with less interferences.
Step5
Specify the SSID for your broadcast SSID and you can also configure multiple SSID at
the same time.
Step6 Verify VLAN identifier to separate services among clients
Step7 Setup the authentication settings.
Step8 Press Apply to save all changes.
Auction: Dual mode uses the same SSID on 5G and 2.4G wireless network.
Note: For more advanced settings, please refer to the previous chapters.
Client Bridge
Step1 Login to the web-based configuration interface with default IP 192.168.1.2
Step2 Change operation mode to Client Bridge.