User manual

10.4 Client Router
In the Client Router Mode, the ENH200EXT has DHCP Server build inside that allows many
LANs automatically generate an IP address to share the same Internet. Connect an AP/WISP
Wirelessly and connect to LANs via wired. Client Router Mode is act completely opposite to
the AP Router Mode.
Please refer to the last section to check Access point’s configuration.
Client Router
Step1 Login to the web-based configuration interface with default IP
192.168.1.1
Step2 Select your country or region’s regulation.
Step3 Select Operation Mode to Client Router from System
Properties.
Step4 Change your Local Area Network setting to Obtain an IP
Address Automatically.
Step5
Use site survey to scan Access Points that are available in nearby
area.
Step6 Select the AP you would like to associate with.
Step7
Setup the authentication settings that match to the Access Point’s
setting.
Step8 Setup your WAN connection type given by your Internet Service
Provider from WAN Settings.
Step9 Press Apply to process all the configurations.
Client Router’s IP setting must match to the Access Point’s subnet.
ENH200EXT
AP / WISP
PC
PC
PC
192.168.1.1
192.168.1.10
192.168.1.11
192.168.1.12