User manual

IP Address Specify WAN port IP address.
IP Subnet Mask Specify WAN IP Subnet Mask.
Gateway IP Address Specify WAN Gateway IP address.
PPTP Server Specify PPTP Server IP address.
Username Specify the Username that is given by your ISP.
Password Specify the Password that is given by your ISP.
Connect on Demand Select the Radio button to specify the maximum idle time.
Internet connection will disconnect when it reach the maximum
idle time, but it will automatically connect when user tries to
access the network.
Keep Alive Select the Radio button to keep internet connection always on.
Specify the redial period once the internet lose connection.
Get Automatically
From ISP
Select the Radio button for get the DNS automatically from DHCP
server.
Use These DNS Servers Select the Radio button for setup the Primary DNS and
Secondary DNS servers manually.
Discard Ping on WAN Place a Check to Enable or Disable ping from WAN.
Accept / Cancel Press Accept to confirm the changes or Cancel to return previous
settings.
Accept does not compile the changes, you must go to Status -> Save/Load to apply the new
settings. Please refer to the chapter 4.1 for more detail.
If the router's MTU is set too high, packets will be fragmented downstream. If the router's
MTU is set too low, the router will fragment packets unnecessarily and in extreme cases may
be unable to establish some connections. In either case, network performance can suffer.