User manual

5 System
5.1 Switching Operation Mode
The ENH200EXT supports 4+1 operation modes: Access Point, Client Bridge, WDS Bridge, and
Client Router. In order to switching between the operating modes, please go to System ->
Operation mode.
Click System Properties under System Section to begin.
.
Device Name: Specify a name for the device. It is not the broadcast SSID. It will be shown in
SNMP management.
Country/Region: Select a Country/Region to conform local regulation.
Operation Mode: Select an operation mode via Radio Button.
Click Accept to confirm the changes.
Accept does not compile the changes, you must go to Status -> Save/Load to apply the new
settings. Please refer to the chapter 4.1 for more detail.