Operation Manual

8.1.4 Client Router Mode
In Client Router Mode, you can access the Internet wirelessly with the support of a WISP. In AP
Router Mode, the ENH200 can access the Internet via a cable or DSL modem. In this mode,
the ENH200 can be configured to turn off the wireless network name (SSID) broadcast, so that
only stations that have the SSID can be connected. The ENH200 also provides wireless LAN
64/128/152-bit WEP encryption security, WPA/WPA2, and WPA-PSK/WPA2-PSK
authentication, as well as TKIP/AES encryption security. It also supports VPN pass-through for
sensitive data secure transmission.
The following figure shows an example of an ENH200 communicating with a Wireless ISP
(WISP) Access Point in Client Router Mode. The sections that follow the figure below describe
how to configure your ENH200 for Client Router Mode.
