User manual

45
9.2. Client Bridge
Client Bridge Mode functions like a wireless dongle. It must connect to an Access Point/AP
Router to join the network.
Please refer to the previous section to check Access point’s configuration.
Client Bridge
Step1 Login to the web-based configuration interface with default IP
192.168.1.1
Step2 Select a Radio to change Operation Mode to Client Bridge(CB)
from System -> Operation Mode.
Step3 Select 802.11a/b/g/n as your wireless mode.
Step4 Use site survey to scan Access Points that are available in nearby
area.
Step5 Select the AP you would like to associate with.
Step6
Setup the authentication settings that match to the Access Point’s
setting.
Step7 Press Apply to process all the configurations.
Note: Client Bridge’s IP setting must match to the Access Point’s subnet.
Access Point /
Wireless Router
Internet
ECB7510
Client
192.168.1.2
192.168.1.1
192.168.1.10