Installation Instructions

Quick Installation Guide

EnGenius Europe | Veldzigt 28, 3454 PW De Meern,

Netherlands | 0900-WIFIABC | www.wiabc.com

Disclaimer: Information may be subject to changes without prior notication.

https://www.linkedin.com/company/engeniuseurope

https://plus.google.com/+EngeniusEuropeBVDeMeern

https://www.youtube.com/user/engeniuseuropebv

https://twitter.com/engeniuseu

STEP 3

After the registration, connect a LAN cable from the LAN port of your existing

Internet modem router to the Ethernet port of the EnGenius Captive Portal Ready

device and power up. The device will perform an initial setup which the status

LED will constantly blink for two minutes. After approximately two minutes, the

product is ready. This can be verified by the 3 LEDs on the device.

(The WLAN LED of the ENS202EXT-CP is not in use in the Captive Portal mode).

For ENS202EXT-CP devices

Note: The ENS202EXT-CP must only be powered with the supplied 24V power

adapter via the PoE (Power-over-Ethernet) injector.

For EAP300-CP devices

Note: The EAP300-CP supports both IEEE802.3af PoE (Power-over-Ethernet) or

the included power adapter. You may use either one as the power source. Do

not use both at the same time.

In the wireless SSID scan, you can find the SSIDs by ‘My Hotspot is getting

ready’. Once the initial setup is completed, you find three SSIDs: MyHotspot,

My Private (key is on the sticker) and Hotspot [part of user ID]@[IP-address]. This

last SSID is the help SSID. This is the IP-address that is assigned on your Local

Area Network. The fourth SSID is the wireless Mesh which is used to repeat the

wireless signal to another device if the other device has not Ethernet connection.

Captive Portal “Ready”

Cloud4Wi