User`s manual

11b/g Wireless Outdoor Multi-Client Bridge/AP Version 1.0
44
 Transmit Power: You may control the output power of the device by selecting a
value from the drop-down list. This feature can be helpful in restricting the coverage
area of the wireless network.
 Layer 2 Isolation: Place a check in this box if you would like to enable the layer 2
isolation feature. This feature will hide the node from the windows network
neighborhood. It is recommended to enable this feature in a hotspot environment.
 WDS: Place a check in this box to enable WDS (Wireless Distribution System).
When WDS is enabled, this access point functions as a wireless repeater and is able
to wirelessly communicate with other APs via WDS links.
Note that WDS is incompatible with WPA -- both features cannot be used at the
same time. A WDS link is bidirectional; so this AP must know the MAC Address
(creates the WDS link) of the other AP, and the other AP must have a WDS link back
to this AP. Make sure the APs are configured with same channel number.
 WDS AP MAC Address: Specify one-half of the WDS link. The other AP must also
have the MAC address of this AP to create the WDS link back to this AP.
 Click on the Save Settings button once you have modified the settings.
4.3.3 SNMP
 Click on the SNMP link under the Wireless menu. This page allows you to SNMP
community and trap settings. The feature is useful while remotely monitoring and
marinating the device.
 SNMP Daemon: Select Enable if you would like to use the SNMP feature.
 Read-Only Community Name: Specify the password for access the SNMP
community for read only access.
 Read-Write Community Name: Specify the password for access to the SNMP
community with read/write access.
 Send SNMP Trap: Select Enable if you would like to receive SNMP traps.
 Send Trap To: Specify the IP address that would receive the SNMP traps.
 Trap Community Name: Specify the password for the SNMP trap community.
 Click on the Save Settings button once you have modified the settings.