User`s manual

11b/g Wireless Outdoor Client Bridge/AP Version 2.1
26
not required, however, when selecting Adhoc mode, you must select the same
channel on all points.
 Enable Universal Repeater Mode: Select Enable to activate Universal Repeater
Mode and type below SSID for extended wireless interface.
4.4.2 Advanced Settings
 Click on the Advanced Settings link under the Wireless menu. On this page you
can configure the advanced settings to tweak the performance of your wireless
network. Options available are: fragmentation threshold, RTS threshold, beacon
interval, output power, preamble type, and 802.11g protection.
 Authentication Type: select an authentication method. Options available are Open
System, Shared Key or Auto. An open system allows any client to authenticate as
long as it conforms to any MAC address filter policies that may have been set. All
authentication packets are transmitted without encryption. Shared Key sends an
unencrypted challenge text string to any device attempting to communicate with the
AP. The device requesting authentication encrypts the challenge text and sends it
back to the access point. If the challenge text is encrypted correctly, the access point
allows the requesting device to authenticate. It is recommended to select Auto if you
are not sure which authentication type is used.
 Fragment Threshold: Packets over the specified size will be fragmented in order to
improve performance on noisy networks.
 RTS Threshold: Packets over the specified size will use the RTS/CTS mechanism to
maintain performance in noisy networks and preventing hidden nodes from
degrading the performance.
 Beacon Interval: Beacons will be sent out to devices at the specified intervals. This
value is measured in milliseconds (ms).