User's Manual

&#
Conguring Advanced Settings
Allofs you to dene the Advanced Settings availaQle on the router.
To vief the Advanced settings, click Wireless then select Advanced.
Frag\ent Threshold
Enter the magimum siie of a packet during data transmission.
A value too lof could lead to lof performance.
RTS Threshold
Enter the RTS threshold. If the packet siie is smaller than the
RTS threshold, the router does not use RTS2TS to send the
data packet.
Beacon Interval
Enter the Qeacon interval. This is the amount of time that the
router sets to synchroniie the netfork.
Delivery TraUc Indication Message (DTIM) Period
Enter the 3TI< period. The 3TI< is a countdofn period informing clients of the negt point
of Qroadcast and multicast of messages over the netfork. Valid values are Qetfeen 1 and 255.
N Data Rate
Select the = data rate. This is the rate in fhich the ESR Series Router fill transmit data packets to fireless = compatiQle devices.
WARNING! Incorrectly changing these settings may cause the device to stop functioning. 3o not modify
the settings in this section fithout a thorough understanding of the parameters.