User's Manual

53
Conguring PPPoE
PointtoPoint Protocol over Ethernet PPPoE is used mainly Qy
ISPs that provide 3SL modems to connect to the Internet.
To vief the PPPoE settings, click Internet, then click PPPoE.
Userna\e
Enter the username assigned Qy an ISP.
Password
Enter the passford assigned Qy an ISP.
Service Na\e
Enter the service name of an ISP optional.
MTU (Maxi\u\ Trans\ission Unit)
Enter the <TU. The <TU species the largest packet siie
permitted for an internet transmission PPPoE default: 1#92.
The <TU siie can Qe set Qetfeen 512 and 1#92.
Authentication Type
Select the type of authentication provided Qy the ISP: Auto, PAP,
or 2HAP. If unsure of the Qest setting, select Auto or check fith
your Internet Service Provider.
Type
2ongure the connection type Qetfeen the router and the
ISP. Select one of the follof
ing: Keep Connection, Auto\atic
Connection or Manual Connection.
Idle Ti\eout
2ongure the magimum idle time 1 to 1, minutes allofed
for an inactive connection.
Clone MAC
Enter the <A2 address of the devices’ netfork interface
card =I2 in the <A2 address eld and click 2lone <A2.
Note: Some ISP providers re`uire registering the <A2 address
of the netfork interface card =I2 connected directly to
the caQle or 3SL modem. 2lone <A2 masks the router’s
<A2 address fith the <A2 address of the computer’s =I2.
2lick Apply to save the settings or Cancel to discard the
changes.