User's Manual
12
Routing Setup
Typically static routing does not need to Qe setup Qecause the router has ade`uate routing information after it has Qeen congured
for Internet access. Static routing is only necessary if the router is connected to netfork under a different suQnets.
To vief the Routing settings, click Advanced then select Routing.
Note: To enaQle a static routing, =AT must Qe disaQled.
If the router is connected fith a netfork under the different
suQnet, the routing setup allofs the netfork connection fithin
tfo different suQnets.
Enable Static Routing
2lick EnaQle Static Routing to activate the feature.
Destination LAN IP
Enter the LA= IP address of the destination device.
Subnet Mask
Enter the SuQnet <ask of the destination device.
DeUault Gateway
Enter the default gatefay IP address for the destination device.
Hops
Enter the magimum numQer of hops fithin the static routing
that a packet is allofed to travel.
InterUace
Select LA= or FA= as the interface.
2lick Add to save the settings and list the conguration in the
2urrent Static Routing taQle or Reset the discard changes.
View and select devices in the Current Static Routing Table.
2lick Delete Selected or Delete All to remove devices
from the taQle. 2lick Reset to stop.
2lick Apply to save the settings or Cancel to discard changes.