User's Manual
Table Of Contents
- ESR600H/ESR750H Dual Concurrent Wireless Media Router
- Table of Contents
- Conventions
- Copyright
- Product Overview
- Installation
- EnGenius Quick Start
- Web Configuration
- Installation Setup Wizard
- Basic Network Settings
- 6.1 System Setup
- 6.2 Configuring WAN Settings
- 6.3 Wireless 2.4G LAN Setup
- 6.4 Wireless LAN 5G Setup
- 6.5 Firewall Setup
- 6.6 Virtual Private Network Setup
- 6.7 Advanced Network Settings
- 6.7.1 NAT Setup
- 6.7.2 Port Mapping Setup
- 6.7.3 Port Forwarding Setup
- 6.7.4 Port Triggering Setup
- 6.7.5 Application Layer Gateway Setup
- 6.7.6 Universal Plug and Play Setup
- 6.7.7 Internet Group Multicast Protocol Setup
- 6.7.8 Quality of Service Setup
- 6.7.9 Routing Setup
- 6.7.10 Wake on LAN Setup
- 6.7.11 USB Port Setup
- 6.8 Tools Setup
- USB Services
- Appendix A
- Appendix B
- Appendix C
- Appendix D
BASIC NETWORK SETTINGS CONFIGURING FILTER
ESR600H/ESR750H 6-36 USER GUIDE
6.3.4 Configuring Filter
When Enable Wireless Access Control is selected, only wireless clients with MAC addresses listed in the table are
allowed to connect to the wireless network.
Enable Wireless Access Control
WARNING!
Incorrectly changing these settings may cause the device to stop functioning. Do not modify the settings in this
section without a thorough understanding of the parameters.
Description Enter a description of the device allowed to
connect to the network.
MAC Address Enter the MAC address of the wireless
device.
Click Add to append a new device to the list or Reset to dis-
card changes.
!