User's Manual
Table Of Contents
- ESR600H/ESR750H Dual Concurrent Wireless Media Router
- Table of Contents
- Conventions
- Copyright
- Product Overview
- Installation
- EnGenius Quick Start
- Web Configuration
- Installation Setup Wizard
- Basic Network Settings
- 6.1 System Setup
- 6.2 Configuring WAN Settings
- 6.3 Wireless 2.4G LAN Setup
- 6.4 Wireless LAN 5G Setup
- 6.5 Firewall Setup
- 6.6 Virtual Private Network Setup
- 6.7 Advanced Network Settings
- 6.7.1 NAT Setup
- 6.7.2 Port Mapping Setup
- 6.7.3 Port Forwarding Setup
- 6.7.4 Port Triggering Setup
- 6.7.5 Application Layer Gateway Setup
- 6.7.6 Universal Plug and Play Setup
- 6.7.7 Internet Group Multicast Protocol Setup
- 6.7.8 Quality of Service Setup
- 6.7.9 Routing Setup
- 6.7.10 Wake on LAN Setup
- 6.7.11 USB Port Setup
- 6.8 Tools Setup
- USB Services
- Appendix A
- Appendix B
- Appendix C
- Appendix D
BASIC NETWORK SETTINGS CONFIGURING ADVANCED SETTINGS
ESR600H/ESR750H 6-30 USER GUIDE
6.3.2 Configuring Advanced Settings
Advanced settings parameters available on the router.
WARNING!
Incorrectly changing these settings may cause the device to stop functioning. Do not modify the settings in this
section without a thorough understanding of the parameters.
Fragment Threshold Enter the maximum size of a
packet during data transmission. A value too low could
lead to low performance.
RTS Threshold Enter the RTS threshold. If the packet
size is smaller than the RTS threshold, the ESR600H/
ESR750H does not use RTS/CTS to send the data
packet.
Beacon Interval Enter the beacon interval. This is the
amount of time that the ESR600H/ESR750H sets to syn-
chronize the network.
Delivery Traffic Indication Message (DTIM) Period
Enter the DTIM period. The DTIM is a countdown period
informing clients of the next point of broadcast and multi-
cast of messages over the network. Valid values are
between 1 and 255.
!