User's Manual
Table Of Contents
- ESR600H/ESR750H Dual Concurrent Wireless Media Router
- Table of Contents
- Conventions
- Copyright
- Product Overview
- Installation
- EnGenius Quick Start
- Web Configuration
- Installation Setup Wizard
- Basic Network Settings
- 6.1 System Setup
- 6.2 Configuring WAN Settings
- 6.3 Wireless 2.4G LAN Setup
- 6.4 Wireless LAN 5G Setup
- 6.5 Firewall Setup
- 6.6 Virtual Private Network Setup
- 6.7 Advanced Network Settings
- 6.7.1 NAT Setup
- 6.7.2 Port Mapping Setup
- 6.7.3 Port Forwarding Setup
- 6.7.4 Port Triggering Setup
- 6.7.5 Application Layer Gateway Setup
- 6.7.6 Universal Plug and Play Setup
- 6.7.7 Internet Group Multicast Protocol Setup
- 6.7.8 Quality of Service Setup
- 6.7.9 Routing Setup
- 6.7.10 Wake on LAN Setup
- 6.7.11 USB Port Setup
- 6.8 Tools Setup
- USB Services
- Appendix A
- Appendix B
- Appendix C
- Appendix D
BASIC NETWORK SETTINGS CONFIGURING DYNAMIC IP
ESR600H/ESR750H 6-14 U
SER GUIDE
6.2.2 Configuring Dynamic IP
Dynamic IP addressing assigns a different IP address each time a device connects to an ISP service provider. The service is
most commonly used by ISP cable providers.
Dynamic IP
Host name Assign a name for the internet connection
type. This field can be blank.
MTU Configure the maximum transmission unit (MTU).
The MTU specifies the largest packet size permitted for an
internet transmission. The factory default MTU size for
Dynamic IP (DHCP) is 1500. The MTU size can be set
between 512 and 1500.
Clone MAC Enter the MAC address of the devices’ net-
work interface card (NIC) in the MAC address field and
click Clone MAC.
Note:
Some ISP providers require registering the MAC
address of the network interface card (NIC) connected
directly to the cable or DSL modem. Clone MAC
masks the router's MAC address with the MAC
address of the device’s NIC.