User's Manual
Table Of Contents
- ESR600H/ESR750H Dual Concurrent Wireless Media Router
- Table of Contents
- Conventions
- Copyright
- Product Overview
- Installation
- EnGenius Quick Start
- Web Configuration
- Installation Setup Wizard
- Basic Network Settings
- 6.1 System Setup
- 6.2 Configuring WAN Settings
- 6.3 Wireless 2.4G LAN Setup
- 6.4 Wireless LAN 5G Setup
- 6.5 Firewall Setup
- 6.6 Virtual Private Network Setup
- 6.7 Advanced Network Settings
- 6.7.1 NAT Setup
- 6.7.2 Port Mapping Setup
- 6.7.3 Port Forwarding Setup
- 6.7.4 Port Triggering Setup
- 6.7.5 Application Layer Gateway Setup
- 6.7.6 Universal Plug and Play Setup
- 6.7.7 Internet Group Multicast Protocol Setup
- 6.7.8 Quality of Service Setup
- 6.7.9 Routing Setup
- 6.7.10 Wake on LAN Setup
- 6.7.11 USB Port Setup
- 6.8 Tools Setup
- USB Services
- Appendix A
- Appendix B
- Appendix C
- Appendix D
WIRELESS SERVICES PRINTER AND SCANNER SHARING
ESR600H/ESR750H 7-6 USER GUIDE
7.1.2 Printer and Scanner Sharing
Auto-Connected Printers
The method described in the previous section, refer to “Using the USB Device Server” on page 7-5, demonstrated manually
connecting and disconnecting to a virtual USB device. That procedure applies to USB storage devices but not to printers,
scanners or multifunction printers (MFPs). For these devices, the USB device server supports auto-connect so users don’t
need to manually connect and disconnect when using the USB device. The following instructions demonstrate how to use this
feature.
To use the auto-connect feature, do the following:
1. Connect the USB printer to the device server’s USB port.
2. Open the Control Centre software to perform a search of available devices.
3. In the Control Center, select the USB device server that has the printer attached.
4. Select the printer.
Note:
A device driver must be installed for the USB device with the Control Centre for the auto-connect feature to work.
Refer to “Installation of a USB Device Driver” on page 7-3.