User's Manual

[ pg. 59]
11.5. PPPoE
• Address Mode: Select Static if your ISP assigned you the IP address,
subnet mask, gateway, and DNS server addresses. In most cases, select
Dynamic.
•
IP Address:
Enter the IP address (Static PPPoE only).
• User Name: Enter your PPPoE user name.
• Password: Enter your PPPoE password.
• Verify Password: Retype the your PPPoE password.
• Service Name: Enter the ISP Service Name (optional).
• Reconnect Mode: Select either Always-on, On-Demand, or Manual.
• Maximum Idle Time: Enter a maximum idle time during which the
Internet connection is maintained during inactivity. To disable this
feature, enable Auto-reconnect.
• MTU: Maximum Transmission Unit - you may need to change the MTU
for optimal performance with your specific ISP. 1492 is the default MTU.
• Obtain A DNS Server Address Automatically: Enable or disable
obtaining a DNS server automatically.
• Primary IPv6 DNS Address: Enter the primary IPv6 DNS address.
• Secondary IPv6 DNS Address:
Enter the secondary IPv6 DNS address.
• Enable DHCP-PD: Enable or disable DHCP-prefix delegation (PD).
• LAN IPv6 Address: Enter the LAN IPv6 address.
• LAN IPv6 Link-Local Address: Enter the LAN IPv6 link-local address.
• Enable Automatic IPv6 Address Assignment: Enable or disable
automatic IPv6 address assignment.
• Autoconfiguration Type: SelectEnter the autoconfiguration type.
(Default: SLAAC +RDNSS)
• Router Advertisement Lifetime: Enter the IPv6 Address Lifetime (in minutes).
Click Apply to save the settings or Cancel to discard changes.