User's Manual
Table Of Contents
- Conventions
- Table of Contents
- Basic Network Settings
- 4.1 System Status
- 4.2 System Setup
- 4.3 Router Setup
- 4.4 Configuring Wireless LAN
- 4.5 Management Setup
- 4.5.1 Configuring Administrator Account
- 4.5.2 Configuring Management VLAN
- 4.5.3 Configuring SNMP
- 4.5.4 Configuring Backup/Restore Settings
- 4.5.5 Configuring Auto Reboot Settings
- 4.5.6 Configuring Firmware Upgrade
- 4.5.7 Configuring System Time
- 4.5.8 Configuring Wi-Fi Schedule
- 4.5.9 Configuring Command Line Interface
- 4.5.10 Configuring Logging
- 4.5.11 Configuring Diagnostics
- 4.5.12 Viewing Device Discovery
- 4.5.13 Configure Denial of Service Protection
- 4.5.14 Logging Out
- Appendix
WALL MOUNTING THE DEVICE
2-3
5. Plug the other end of the Ethernet cable into the PoE port
of the PoE injector.
Figure 2-1: Installing the EnStation 5
6. Turn over the EnStation 5. Then insert the pole mounting
strap through the middle hole of the EnStation 5. Use a
screwdriver to unlock the pole-mounting ring putting it
through the EnStation 5.
7. Mount the EnStation 5 securely to the pole by locking the
strap tightly.
This completes the installation procedure.
Wall Mounting the Device
1. Plug the dynamic stick into the bracket firstly.
2. Combine the sealing nut and the assembled kit, as well
as tighten it.
3. Put the mock washer on dynamic stick.
4. Assemble the mounting kit with the CPE.
5. Drill the hole to input the mounting screws.
6. Use the included screws to input the mounting screws.
7. Let the hole of the bracket to aim at the screws on the
wall and hang the device to fix it.
Figure 2-2: Wall Mounting the Device