User's Manual
Table Of Contents
- Conventions
- Table of Contents
- Basic Network Settings
- 4.1 System Status
- 4.2 System Setup
- 4.3 Router Setup
- 4.4 Configuring Wireless LAN
- 4.5 Management Setup
- 4.5.1 Configuring Administrator Account
- 4.5.2 Configuring Management VLAN
- 4.5.3 Configuring SNMP
- 4.5.4 Configuring Backup/Restore Settings
- 4.5.5 Configuring Auto Reboot Settings
- 4.5.6 Configuring Firmware Upgrade
- 4.5.7 Configuring System Time
- 4.5.8 Configuring Wi-Fi Schedule
- 4.5.9 Configuring Command Line Interface
- 4.5.10 Configuring Logging
- 4.5.11 Configuring Diagnostics
- 4.5.12 Viewing Device Discovery
- 4.5.13 Configure Denial of Service Protection
- 4.5.14 Logging Out
- Appendix
PRODUCT INTERFACE
1-5
1.3 Product Interface
Figure 1-1: Back Panel View
INTERFACE DESCRIPTION
ALAN Port(PoE)
The PoE interface allows EnStation to be
powered using the supplied PoE injector
B LAN Port
To configure EnStation, connect to an
Ethernet adapter in a computer for accessing
more information
C Reset Button
To reset factory settings, press button more
than 10 seconds.
D Power LED
OFF=EnStation is not receiving power
ON=EnStation is receiving power
E LAN(2) LEDs
OFF=EnStation is not connected to the
network
ON=Enstation is connected to the network
but not sending or receiving data
FWAN LED
(Access Point or Client Bridge Mode)
OFF=EnStation radio is off and the device is
not sending or receiving data over the
wireless LAN
ON=EnStation radio is on, and the device is
not sending or receiving data over the
wireless LAN.
Blinking=EnStation radio is on, and the
device is sending or receiving data over the
wireless LAN.
G Signal Indicator LED
(Client Bridge, WDS Station and Client
Router Mode)
I
NTERFACE DESCRIPTION