User's Manual
Table Of Contents
- Table of Contents
- Product Overview
- Installation
- Web Configuration
- Basic Network Settings
- 4.1 System Status
- 4.2 System Setup
- 4.3 Router Setup
- 4.4 Configuring Wireless LAN
- 4.5 Management Setup
- 4.5.1 Configuring Administrator Account
- 4.5.2 Configuring Management VLAN
- 4.5.3 Configuring SNMP
- 4.5.4 Configuring Backup/Restore Settings
- 4.5.5 Configuring Auto Reboot Settings
- 4.5.6 Configuring Firmware Upgrade
- 4.5.7 Configuring System Time
- 4.5.8 Configuring Wi-Fi Schedule
- 4.5.9 Configuring Command Line Interface
- 4.5.10 Configuring Logging
- 4.5.11 Configuring Diagnostics
- 4.5.12 Viewing Device Discovery
- 4.5.13 Configure Denial of Service Protection
- 4.5.14 Logging Out
- Appendix A
- Appendix B
- Appendix C
BASIC NETWORK SETTINGS CONFIGURING SYSTEM TIME
4-46
4.5.7 Configuring System Time
Change the system time of the ENS500 by manually entering the information, synchronizing the device with a PC, or setup automatic
updates through a network time (NTP) protocol server.
Manually Set Date and Time Enter the date and time values in
the date and time fields or click the Synchronize with PC
button to get the date and time values from the administrator’s
PC.
Automatically Get Date and Time Select a time zone from the
drop-down list and check whether you want to enter the IP
address of an NTP server or use the default NTP server.
Enable Daylight Saving Click to enable or disable daylight
savings time. Select the start and stop times from the Start
Time and Stop Time dropdown lists.
Click Save/Apply to apply the changes or Cancel to return
previous settings.