User's Manual
Table Of Contents
- Table of Contents
- Product Overview
- Installation
- Web Configuration
- Basic Network Settings
- 4.1 System Status
- 4.2 System Setup
- 4.3 Router Setup
- 4.4 Configuring Wireless LAN
- 4.5 Management Setup
- 4.5.1 Configuring Administrator Account
- 4.5.2 Configuring Management VLAN
- 4.5.3 Configuring SNMP
- 4.5.4 Configuring Backup/Restore Settings
- 4.5.5 Configuring Auto Reboot Settings
- 4.5.6 Configuring Firmware Upgrade
- 4.5.7 Configuring System Time
- 4.5.8 Configuring Wi-Fi Schedule
- 4.5.9 Configuring Command Line Interface
- 4.5.10 Configuring Logging
- 4.5.11 Configuring Diagnostics
- 4.5.12 Viewing Device Discovery
- 4.5.13 Configure Denial of Service Protection
- 4.5.14 Logging Out
- Appendix A
- Appendix B
- Appendix C
BASIC NETWORK SETTINGS CONFIGURING LAN SETTINGS
4-17
4.3.2 Configuring LAN Settings
IP Address Enter the LAN port IP address.
IP Subnet Mask Enter the LAN IP subnet mask.
WINS Server IP Enter the WINS Server IP.
Use Router As DHCP Server Check this option to enable the
ENS500 internal DHCP server.
Starting IP Address Specify the starting IP address range for
the pool of allocated for private IP addresses. The starting IP
address must be on the same subnet as the ending IP address;
that is the first three octets specified here must be the same as
the first three octets in End IP Address.
Ending IP Address Specify the ending IP address range for the
pool of allocated for private IP addresses. The ending IP address
must be on the same subnet as the starting IP address; that is
the first three octets specified here must be the same as the first
three octets in Start IP Address.
WINS Server IP Enter the IP address of the WINS server.
Click Accept to confirm the changes or Cancel to cancel and return previous settings.