User's Manual
Table Of Contents
- Table of Contents
- Product Overview
- Installation
- Web Configuration
- Basic Network Settings
- 4.1 System Status
- 4.2 System Setup
- 4.3 Router Setup
- 4.4 Configuring Wireless LAN
- 4.5 Management Setup
- 4.5.1 Configuring Administrator Account
- 4.5.2 Configuring Management VLAN
- 4.5.3 Configuring SNMP
- 4.5.4 Configuring Backup/Restore Settings
- 4.5.5 Configuring Auto Reboot Settings
- 4.5.6 Configuring Firmware Upgrade
- 4.5.7 Configuring System Time
- 4.5.8 Configuring Wi-Fi Schedule
- 4.5.9 Configuring Command Line Interface
- 4.5.10 Configuring Logging
- 4.5.11 Configuring Diagnostics
- 4.5.12 Viewing Device Discovery
- 4.5.13 Configure Denial of Service Protection
- 4.5.14 Logging Out
- Appendix A
- Appendix B
- Appendix C
BASIC NETWORK SETTINGS POINT-TO-POINT TUNNELLING PROTOCOL (PPTP)
4-16
Use These DNS Servers Click the radio button to set up the Primary DNS and Secondary DNS servers manually.
Discard Ping on WAN Check to Enable to recognize pings on the ENS500 WAN interface or Disable to block pings on the ENS500
WAN interface. Note: Pinging IP addresses is a common method used by hackers to test whether the IP address is valid. Blocking
pings provides some extra security from hackers.
Click Accept to save the settings or Cancel to discard changes.