User's Manual
Table Of Contents
- Table of Contents
- Product Overview
- Installation
- Web Configuration
- Basic Network Settings
- 4.1 System Status
- 4.2 System Setup
- 4.3 Router Setup
- 4.4 Configuring Wireless LAN
- 4.5 Management Setup
- 4.5.1 Configuring Administrator Account
- 4.5.2 Configuring Management VLAN
- 4.5.3 Configuring SNMP
- 4.5.4 Configuring Backup/Restore Settings
- 4.5.5 Configuring Auto Reboot Settings
- 4.5.6 Configuring Firmware Upgrade
- 4.5.7 Configuring System Time
- 4.5.8 Configuring Wi-Fi Schedule
- 4.5.9 Configuring Command Line Interface
- 4.5.10 Configuring Logging
- 4.5.11 Configuring Diagnostics
- 4.5.12 Viewing Device Discovery
- 4.5.13 Configure Denial of Service Protection
- 4.5.14 Logging Out
- Appendix A
- Appendix B
- Appendix C
BASIC NETWORK SETTINGS CONFIGURING IP SETTINGS
4-10
4.2.2 Configuring IP Settings
Configure the ENS500 LAN settings for the ENS500 using a static or dynamic IP address.
IP Network Setting Configure the network connection type using
either a static IP or dynamic IP.
IP Address Enter the LAN IP address of the ENS500.
Subnet Mask Enter the subnet mask of the ENS500.
Default Gateway Enter the default gateway of the ENS500.
Primary DNS Enter the primary DNS address of the ENS500.
Secondary DNS Enter the secondary DNS address of the
ENS500.
Use Link-Local Address Click to enable a link-local address for
the device.
IPv6 IP Address Enter the IPv6 LAN IP address of the ENS500.
IPv6 Subnet Prefix Length Enter the IPv6 subnet prefix length of
the ENS500.
IPv6 Default Gateway Enter the IPv6 default gateway of the
ENS500.
IPv6 Primary DNS Enter the IPv6 primary DNS of the ENS500.
IPv6 Secondary DNS Enter the IPv6 secondary DNS of the ENS500.
Click Apply to save the settings or Cancel to discard changes.