User's Manual
Table Of Contents
- Conventions
- Table of Contents
- Basic Network Settings
- 4.1 System Status
- 4.2 System Setup
- 4.3 Router Setup
- 4.4 Configuring Wireless LAN
- 4.5 Management Setup
- 4.5.1 Configuring Administrator Account
- 4.5.2 Configuring Management VLAN
- 4.5.3 Configuring SNMP
- 4.5.4 Configuring Backup/Restore Settings
- 4.5.5 Configuring Auto Reboot Settings
- 4.5.6 Configuring Firmware Upgrade
- 4.5.7 Configuring System Time
- 4.5.8 Configuring Wi-Fi Schedule
- 4.5.9 Configuring Command Line Interface
- 4.5.10 Configuring Logging
- 4.5.11 Configuring Diagnostics
- 4.5.12 Viewing Device Discovery
- 4.5.13 Configure Denial of Service Protection
- 4.5.14 Logging Out
- Appendix
WI-FI PROTECTED ACCESS PRE-SHARED KEY (WPA-PSK) MIXED
4-31
Wi-Fi Protected Access Pre-Shared Key (WPA-PSK) Mixed
Security Mode
Select WPA2-PSK Mixed from the drop-down
list to begin the configuration.
Encryption Select Both, TKIP, or AES as the encryption type.
Both = uses TKIP and AES.
TKIP = automatic encryption with WPA-PSK; requires pass-
phrase.
AES = automatic encryption with WPA2-PSK; requires passphrase.
Passphrase Specify the security password. For security, each typed character is masked by a dot.
Group Key Update Interval Specify how often, in seconds, the group key changes.
Click Save to save the changes or Cancel to cancel and return previous settings.
Note:
WPA-PSK Mixed can allow multiple security modes at the same time. 802.11n does not allow WEP/WPA-PSK TKIP/WPA2-PSK TKIP
security mode. The connection mode will change from 802.11n to 802.11a.