User's Manual

INSTALLATION INSTALLING THE DEVICE
2-3
5. Plug the other end of the Ethernet cable into the PoE port
of the PoE injector.
Figure 2-1: Installing the ENH500
6. Turn over the ENH500. Then insert the pole mounting
strap through the middle hole of the ENH500. Use a
screwdriver to unlock the pole-mounting ring putting it
through the ENH500.
7. Mount the ENH500 securely to the pole by locking the
strap tightly.
This completes the installation procedure.
Mounting the ENH500
ToinstalltheENH500,usethefollowingproceduretomountthe
deviceonawallandrefertothefigurebelow
Anchor:8mm(D)x25mm(L);Screw:5.5mm(D)x18mm(L)
Figure2-2:WallMoutingtheENH500
1. Attach the mounting bracket to the wall using the provide
wall mounting hardware kit.
2. Drill the holes to input the mounting screws.
3. Place the ENH500 on the wall.