User's Manual

Management VLAN Settings

This page allows you to assign a VLAN tag to the packets. A

VLAN is a group of computers on a network whose software

hasbeenconguredsothattheybehaveasiftheywereon

a separate Local Area Network (LAN). Computers on VLAN

do not have to be physically located next to one another

on the LAN.

Note: Only applicable in Access Point and WDS AP mode.

Prole Isolation: Restricted client to communicate with

different VID by selecting the radio button.

VLAN ID: SpecifytheVLANtagforeachprole.

Management VLAN ID: If your network includes VLANs,

you can specify a VLAN ID for packets pass through the

Access Point with a tag. Otherwise, select No VLAN tag.

Accept / Cancel: Click Accept to conrm the changes or

Cancel to cancel and return previous settings.

Note:

1. If you recongure the Management VLAN ID, you

may lose your connection to the EAP900H. Verify that

the DHCP server supports the recongured VLAN ID

and then reconnect to the EAP900H using the new IP

address.

2. Clicking Accept does not apply the changes. To apply

them, use Status > Save/Load (see section 5.1).