Datasheet

Contents
Accessories
Type B 50 Set
l off the line, rechargeable nickel cadmium-batteries
l heats up in 9 secs.
l *) up to 350 consecutive soldering operations
l up to 100 soldering joints if tip is allowed to cool off and
reheated for every 2 soldering joints
l light fittings (1 or 2 lights attachable by choice)
l fully rechargeable at night in approx. 8 hrs or during breaks
l built-in charging contol, overcharging impossible
l safety knob to prevent accidental operation
l operational indicator
l tip temperature approx. 350°C
l long life tip protected against erosion and oxidation
l no disturbance toexternal voltage while soldering
l weight: 160g (total weight with packaging 510g)
*) This figure has been obtained 0,5mm Ø dia.
wire of electronic components without recharging the batteries.
The lighting reduces the soldering efficiency by approx. 7%
per blub. Total on-transition time per battery load is approx.
13 minutes.
1 ENGEL-Soldering Gun
1 long life tip
1 long life tip
1 long life tip
1 coil solder approx. 4g
1 tip cover
2 lights
1 cleaning pad
1 charging unit
1 screw driver
Type B 50 A
Type B 50 D
Type B 50 H
Type B 50 G
Type B 50 T
Type B 50 E
Type B 50 R
Type B 50 L
Charging Cable B 50 K
l For recharging of the ENGEL soldering unit
B 50 SET from 12 VDC sources.
l The charging cable plug will fit all standard
low voltage (12VDC) cigarette lighter sockets
in cars and boats fitted with negative ground.
l As the recharging current is very low at
approx. 0,15A there will be little drain only on
the car battery even when the motor is not running.
Service-Box B 50 B
l for secure storage of the ENGEL soldering unit
B 50 SET in the tool bag
l A safe place to deposit the ENGEL soldering unit
B 50 SET during charging operation in cars and boats.
l The indispensable, unbreakable case with the
useful safety-lock.
l Soldering unit, soldering tip, srewdriver and
cleaning pad fit into the Service Box.