User manual

2.3 Rear Panel
Figure 3.Rear Panel
1. SAT IN
Connect the digital signal from your LNB on the satellite dish to this connector.
2. SAT OUT
Gives you the possibility to connect an extra receiver (analogue or digital).
3. TV SCART
Use this connector to connect your receiver to your video recorder using a SCART
cable. Your video signal will now be looped through your receiver to your TV set.
4.VCR SCART Connector
Use this connector to connect your receiver to your video recorder using a SCART
cable.
5.CVBS
Video Output.
6. AUDIO Right and Left
These connectors give you the possibility to connect the audio signal to an external
amplifier, or the audio input of your TV.
7.S/PDIF
Use this output to connect your receiver to the input of your digital audio amplifier.
8. Power Cord
Your receiver requires a current of 100~240V AC (Auto-selectable), 50~60Hz +/-5%.
Check the power specification before connecting your receiver to the wall outlet.
5