Owner`s manual

ENFORCER SLI 820R/-4 Owner's Manual
SECO-LARM U.S.A., Inc.
Page 6
NOTE  When using the factory remote, the
shock sensor (and other add-on sensors), and
current sensing will not trigger the alarm until 60
seconds after the alarm is armed.
NOTE  When using the ENFORCER remote, the
shock sensor (and other add-on sensors), and
current sensing will not trigger the alarm until 4
seconds after the alarm is armed.
Ask your dealer about the shock sensor.
Your alarm includes a patented dual-stage shock
sensor.
The first stage (pre-intrusion alert) warns thieves
the alarm is armed. For instance, the alarm will
chirp three times and the parking lights will flash
three times if the sensor detects a light bump to
the vehicle. However, if a thief attacks the car with
sufficient force, the alarm will trigger. (Your dealer
can make the shock sensor more or less sensitive
to attack, depending on your vehicle.)
If your alarm was triggered when you were away,
the siren will chirp two times and the parking lights
flash seven times when you disarm your alarm.
The LED flashes in quick cycles to show where the
car was violated as follows:
l 1 flash  The ignition was turned on.
l 2 flashes  The alarm was triggered via
panic on the ENFORCER remote.
l 3 flashes  Shock
sensor or other add-on
sensor was triggered.
l 4 flashes  A door was opened.
l 5 flashes  The hood or trunk was opened.
l 6 flashes  The current sensing was triggered.
These memory flashes automatically reset when
the ignition is turned ON.
TAMPER INDICATORS & TRIGGER ZONE ID
Sometimes you may not wish your alarm to arm
when you leave your vehicle. (For instance, if you
leave your car with a valet attendant, you may not
want to teach him how the alarm operates.) If your
alarm is set for active (manual) arming, this is
easy  dont press the Lock button, and the alarm
will not arm. However, if your alarm is set to arm
passively, use the valet mode to prevent it from
arming.
To enter valet, first disarm the alarm and turn the
ignition ON. Within 15 seconds, press and release
the VEPLe button three times. The alarm is now in
the valet mode. The siren chirps and the parking
lights flash once to confirm. (Your alarm also goes
into valet when you use emergency disarm. See
EMERGENCY DISARM on page 5).
To exit valet, just turn the ignition ON and, within
15 seconds, press and release the VEPLe button
three times. The siren chirps twice and the parking
lights flash twice to confirm that valet is exited and
the alarm is now disarmed.
If you press the Lock or Unlock button on the
factory remote while the alarm is in valet, the
doors will lock or unlock, and the parking lights
will flash four times. The alarm's emergency call
for help and 2nd channel output operate normally
(ENFORCER remote only).
VALET
DUAL-STAGE SHOCK SENSOR
Your alarm can be programmed for ignition-
controlled operation (doors lock when you turn the
IGNITION-CONTROLLED POWER DOOR LOCKS
ignition ON, and/or unlock when the ignition is
turned OFF). Consult your dealer.