Owner`s manual

ENFORCER SLI 820R/-4 Owner's Manual
Page 11
Programmable features allow you to customize your
alarm. Your dealer can program them when the
alarm is installed.
l Permanent chirp delete  Permanently
enables or disables the sirens chirps.
l Passive/active arming  In passive arming,
the alarm arms itself when you turn the ignition
OFF and close the last open door. In active
arming, press the factory transmitter lock
button or ENFORCER transmitter
button to
arm the alarm.
l SecureLock
TM
lock  If this feature is enabled,
in the passive arming mode, when the alarm
automatically rearms, the doors will lock
automatically. In the active arming mode, if a
door or trunk is not opened within 30 seconds
of disarming, the alarm automatically re-arms
and the doors automatically re-lock.
l Current sensing  Current sensing with
switch sensing, or switch sensing only.
l Ignition-controlled door lock and unlock 
Can be set to lock and/or unlock the doors
automatically when the ignition is turned ON
and/or OFF.
Appendix 3  PROGRAMMABLE FEATURES
l Horn or siren warning  Choose whether the
alarm will honk your cars horns or sound a
super-loud siren.
l Ignition domelight If this feature is enabled,
whenever you disarm the alarm, your cars
domelights turn ON for 30 seconds.
l Pulse or continuous horn output  This
chooses how the car horn sounds when the
alarm is triggered.
l
Door error indicator ON/OFF - Under active
arming, if ON, when the transmitter button is
pressed to arm the alarm the siren chirps
three times and lights flashes three times if a
door is open or the delayed domelights are ON
to show the alarm has armed anyway. If OFF,
the siren chirps once and lights flash once
when the transmitter button is pressed to arm
the alarm. In this case, you may not be able
to tell if the doors are closed properly.
l Comfort mode  If enabled, the door lock
timing is extended to 25 seconds. This allows
the sunroof to close properly in some cars.
A. Arming indicator  Flashes quickly during the
30-second rearm to show passive arming
countdown.
B. Door open indicator  OFF when a hardwired
door is opened during the 30-second rearm or
passive arming countdown.
C. Armed indicator  Flashes when the alarm is
armed.
D. Disarmed indicator  OFF when the alarm is
disarmed.
Appendix 2  UNDERSTANDING THE LED FLASHES
E. Tamper and triggered zone ID  Flashes one
or more times after the alarm is disarmed to
indicate which zone was triggered.
F. RF reception indicator  ON while any
ENFORCER transmitter button is pressed.
G. Valet mode indicator  Flashes slowly to
indicate system is in valet mode.