User guide

GSM1308 Quad-Band
SA-G+ User Manual
GSM1308UG001 21 Version 1.02 – 10/29/08
6 Configure the SA-G+ to talk to the Enfora Server
1. Connect and verify Serial connectivity with the Enfora SA-G+.
a) Connect the PC serial connector to the SA-G+ serial port.
Note: In the following instructions, <CR> means using the
Enter Key on the keyboard.
With HyperTerminal open, hit the Enter key. The SA-G+
should respond with OK. If you do not see this response,
double-check your connections.
b) Type AT<CR>. The SA-G+ should respond with OK. If you
do not see the letters AT, send the following command to the
SA-G+: ATE1<CR>
c) Type ATI<CR>. The SA-G+ should respond with Enfora,
Inc. If you get any different response, you are not connected
to the Enfora SA-G+.