User guide

GSM1308 Quad-Band
SA-G+ User Manual
GSM1308UG001 16 Version 1.02 – 10/29/08
5 Configure the Computer and Verify Correct Communications
Note: The following examples use Windows 2000 and HyperTerminal.
Any Terminal program should work, using the parameters in Step 1.
1. Default Serial Parameters
a) Autobaud (power up message at115200 baud rate)
b) 8 data bits
c) 1 stop bit
d) No Parity
e) Flow Control = None
2. Determine which Com port to use
a) On older computers, there is usually a built in Com port. This
is normally Com1.
b) If you are using a USB-to-serial converter, you will need to
determine which Com port it is installed on.
Note: If the USB-to-serial converter has not been
installed, install the necessary drivers per the
instruction supplied by your USB-to-Serial device.
Then leave the device unplugged.
c) Open up the System Properties window. This is done
through the Control Panel > System or right-click on My
Computer and select Properties. Select the Hardware Tab.
On Windows 2000 the screen looks like the following: