User guide

GSM1308 Quad-Band
SA-G+ User Manual
GSM1308UG001 5 Version 1.02 – 10/29/08
2 Regulatory Compliance
2.1 FCC
The modem was tested and certified to meet FCC Parts 15 in a stand-alone
configuration, which demonstrated that the GSM1308 SA-G+ complies with Part
15 emission limits. FCC Part 22 & Part 24 is covered by the Enfora Enabler-IIIG
"modular approval" process for a transmitter. This approach, described by FCC
Public Notice DA 00-131407 released June 26, 2000, is intended to afford relief
to equipment manufacturers by eliminating the requirement for obtaining a new
equipment authorization for the same transmitter when installed in a new device.
In order to use the GSM1308 SA-G+ without additional FCC certification
approvals, the installation must meet the following conditions:
• A separation distance of at least 20 cm (7.87 inches) between the
antenna and the body of the user and other persons must be
maintained at all times.
• GSM 850 mode: With the maximum conducted power at 32 dBm,
the maximum antenna gain is 4.5 dBi (2.35 dBd) in order to meet
maximum 7 watt ERP for mobile transmitters and MPE (Maximum
Permissible Exposure) requirement of General
Population/Uncontrolled exposures.
• GSM 1900 mode: With the maximum conducted power at 31dBm,
the maximum antenna gain is 2 dBi in order to meet maximum 2
watt EIRP for mobile transmitters and MPE (Maximum Permissible
Exposure) requirement of General Population/Uncontrolled
exposures.
2.2 R&TTE -
The GSM1308 SA-G+ modem has been fully tested and complies with all the
requirements of EN301 489-1, EN301 489-7 and EN60950-1:2001. Compliance
to EN 301 511 has been demonstrated by testing on both the GSM1308 and the
integrated GSM0308 module. At the separation distance of at least 20 cm (7.87
inches) between the antenna and the body of the user and other persons, the
product also meet EN50392 MPE requirement.