Specifications
AT Command Set Reference
Ver. 1.00
GSM1308AT001 Page 288 Ver. 1.00 – 10/29/2008
19 0 0 Set GPIO #4 configured as Output to High (1)
20 0 0 Set GPIO #5 configured as Output to High (1)
21 0 0 Set GPIO #6 configured as Output to High (1)
22 0 0 Set GPIO #7 configured as Output to High (1)
23 0 0 Set GPIO #8 configured as Output to High (1)
24 0 0 Toggle GPIO #1 configured as Output
25 0 0 Toggle GPIO #2 configured as Output
26 0 0 Toggle GPIO #3 configured as Output
27 0 0 Toggle GPIO #4 configured as Output
28 0 0 Toggle GPIO #5 configured as Output
29 0 0 Toggle GPIO #6 configured as Output
30 0 0 Toggle GPIO #7 configured as Output
31 0 0 Toggle GPIO #8 configured as Output
32
See GPIO Flash
Table below
Flash GPIO #1 configured as Output
33 Flash GPIO #2 configured as Output
34 Flash GPIO #3 configured as Output
35 Flash GPIO #4 configured as Output
36 Flash GPIO #5 configured as Output
37 Flash GPIO #6 configured as Output
38 Flash GPIO #7 configured as Output
39 Flash GPIO #8 configured as Output
40
0 to –1
See Bit-
Field
Table
below
Generate and transmit one UDP Message to first
IP address listed in $FRIEND command and port
number listed in $UDPAPI command based on
Parm1 and Parm2 values
41 Generate and transmit a UDP message with
Acknowledge. This message is controlled by
$ACKTM command for number of retries sent.
This message has to be acknowledged to avoid
sending of retries.
42 Generate and transmit one UDP Message to all
IP address listed in $FRIEND command and port
number listed in $UDPAPI command based on
Parm1 and Parm2 values
43
1 – 8 0
Resets the timer (Timer #1 – Timer #8) specified
by Parm1 to the time (in seconds) specified by
Parm2. Parm2, when set to 0, resets the timer
to the time last set by $EVTIMx command. A
value other than 0 would set the timer to expire at
the new specified interval (e.g. xx,3,43,1,180
would set timer 1 to expire in 180 seconds).
44
1 – 15 0
Execute AT command stored at index number of
the $STOATEV command. Parm1 identifies the
index number.
45
0-
2147483
647
See Bit-
Field
Table
below
Sends data over SMS to All SMS destination
addresses configured via $SMSDA command.
(For select $SMSDA entries, see event categories
54-58)
46 N/A N/A Reserved
47 0 0 to –1 Input Event Counter
48
0 0 to –1
Input Event Counter reset to value stated by
parm2