User guide

Enfora GSM1308 and
GSM1318
Quad-Band Spider®
SA-G+
User Guide P a g e 14 Revision: 1.03
4 Configure the Computer and Verify
Correct Communications
Note: The following examples use Windows 2000 and
HyperTerminal. Any Terminal program should work, using the
parameters in Step 1
1. Default Serial Parameters
a. Autobaud (power up message at115200 baud rate)
b. 8 data bits
c. 1 stop bit
d. No Parity
e. Flow Control = None
2. Determine which Com port to use
f. On older computers, there is usually a built in Com port. This is normally
Com1.
g. If you are using a USB-to-serial converter, you will need to determine
which Com port it is installed on.
Note: If the USB-to-serial converter has not been installed,
install the necessary drivers per the instruction supplied by
your USB-to-Serial device. Then leave the device
unplugged.
h. Open up the System Properties window. This is done through the
Control Panel > System or right-click on My Computer and select
Properties. Select the Hardware Tab. On Windows 2000 the screen
looks like the following: