User manual

Setting TCEQ Networking Parameters for an Enfora GSM 1208
4
The settings can be saved for another modem. Press OK again to return to Hyperterminal
window and connect. Once connected, type “ATI” and press enter. The message “Enfora,
L.P.” should appear followed by an “OK.”
Type the following commands and press enter. An “OK” should appear after each
command is executed. Each command can be entered in upper or lower case (AT&F and
at&f are valid). The first command sets the Enfora to factory defaults, the second stores
the changes, and the third changes the baud rate of the modem to 9600.
AT&F
OK response
AT&W
OK response
AT+IPR=9600
OK response
NOW disconnect HyperTerminal and modify the connection properties to 9600
baud, and reconnect. The modem can stay powered while doing this part. To test
connection, type “ATI” and press enter and wait for an “OK” response.
Create the following text file by copying from this document and pasting into Notepad or
a word processor and save as text file with a filename and with the extension “.txt”.
Leave no additional spaces between the lines or lines at the beginning of the file. Make
sure to assign a modem channel number and remove the comment in parenthesis.
AT$PADSRC=2000
AT$PADTO=1
AT$HOSTIF=2
AT$ACTIVE=0
AT&W
AT+CGDCONT=1,”IP”,”TCEQ.CCS”,,0,0
AT%CGPCO=1,”[e-mail],TCEQ12”,0 (xx = the assigned
modem channel/IP number-remove this comment)
AT&W
AT%CGPPP=1
AT$NETMON=15,1,0,1
AT$AREG=2
AT&W
AT$EVTIM1=43200
AT$STOATEV=1,AT$RESET
AT$EVENT=10,0,12,1,1
AT$EVENT=10,3,44,1,0
AT&W