User manual

Setting TCEQ Networking Parameters for an Enfora GSM 1208

Click on Window's Hyperterminal (Start

Programs

Accessories

Communications

Hyperterminal) and set up the COM connection with the following values. These are the

factory defaults for the GSM 1208 modem:

Bits per second: 115200

Data bits: 8

Parity: None

Stop bits: 1

Flow Control: None

To set up the connection, go under File-

Properties to reach this dialog box:

Find the COM port to connect to under the Connect Using menu item. Go under the

“Configure” button to set the communication settings. After pressing the “OK” button,

the modem should connect.

If the properties window above is grayed and it is not possible to highlight any item in the

box, make sure to disconnect first while in Hyperterminal and return to the window

again.

If using a USB to Serial interface or PCMCIA card on a laptop and it is not obvious

which COM port Windows automatically selected, find the “System” icon under the

Control Panel in Windows. If it is necessary to install a “driver” for the USB to serial or

serial card, follow the onscreen instructions and make sure the files are available before

installing.

Find the COM port number by doing the following:

Press the START button---->Settings--->Control Panel----->System--->Hardware tab---

>Device Manager button. Look for the label that says “Ports (COM & LPT)” with a +