User guide

SA-EL User Manual
Ver. 1.00
EDG1228UG001 3 Version 1.00 – 3/30/2006
Figure 2 - Rear view of SA-EL modem.
1.7 Regulatory Compliance FCC
1.7.1 FCC
The modem was tested and certified to meet FCC Parts 15 in a stand-alone
configuration, which demonstrated that the GSM1208 SA-G complies with Part
15 emission limits. FCC Part 22 & Part 24 is covered by the Enfora Enabler-IIG
"modular approval" process for a transmitter. This approach, described by FCC
Public Notice DA 00-131407 released June 26, 2000, is intended to afford relief
to equipment manufacturers by eliminating the requirement for obtaining a new
equipment authorization for the same transmitter when installed in a new device.
In order to use the GSM1208 SA-G without additional FCC certification
approvals, the installation must meet the following conditions:
For the transmitter to meet the MPE categorical exclusion requirements of
2.1091, the ERP must be less than 1.5 watts for personnel separation distance of
at least 20 cm (7.9 in). Therefore, the maximum antenna gain cannot exceed
+3.3dBi. If greater than 1.5 watts exists, then additional testing and FCC
approval is required.
1.7.2 R&TTE -
The GSM1208 SA-G modem has been fully tested and complies with all the
requirements of EN301 489-1, EN301 489-7 and EN60950-1:2001. Compliance
to EN301 511 has been demonstrated by testing on both the GSM1208 and the
integrated GSM0108 module.