User Guide: EDG1228UG001 Enfora ® EDG1228 Quad-Band SA-EL - User Manual Revision 1.
SA-EL User Manual Ver. 1.00 Document Title: Manual Enfora GSM/GPRS/EDGE Quad-Band SA-EL User Version: 1.00 Date: 03/30/06 Status: Released Document Control ID: EDGE1228UG001 General All efforts have been made to ensure the accuracy of material provided in this document at the time of release. However, the items described in this document are subject to continuous development and improvement.
SA-EL User Manual Ver. 1.00 Limited Warranty ENFORA Inc. 12-MONTH LIMITED WARRANTY Enfora warrants to the original purchaser of the product that, for a period of one (1) year from the date of product purchase, the product hardware, when used in conjunction with any associated software (including any firmware and applications) supplied by Enfora, will be free from defects in material or workmanship under normal operation.
SA-EL User Manual Ver. 1.00 covered defect of which purchaser notifies Enfora during the applicable warranty period.
SA-EL User Manual Ver. 1.00 may also be available to purchaser (e.g., the product may be returned to Enfora through the distributor or reseller). This limited warranty shall be governed by the laws of the State of Texas, United States of America, without regard to conflict of laws principles. This limited warranty shall not be governed in any respect by the United Nations Convention on Contracts for the International Sale of Goods. EDG1228UG001 iv Version 1.
SA-EL User Manual Ver. 1.00 Revision History Revision Number 1.00 EDG1228UG001 Release Date Description of Changes 03/30/06 Initial Release v Version 1.
SA-EL User Manual Ver. 1.00 Table Of Contents 1 Introduction ....................................................................................................1 1.1 About the SA-EL.....................................................................................1 1.2 About this Manual...................................................................................1 1.3 System Requirements ............................................................................2 1.
SA-EL User Manual Ver. 1.00 Figures Figure 1 - Front view of SA-EL modem.................................................................2 Figure 2 - Rear view of SA-EL modem. ................................................................3 Figure 3 - Inserting a SIM Card in a SA-EL Module ..............................................5 Figure 4 - Connecting The Power Supply To SA-EL.............................................6 Figure 5 - SA-EL Connecting the Antenna......................................
SA-EL User Manual Ver. 1.00 1 1.1 Introduction About the SA-EL The GSM/GPRS/EDGE SA-EL (hereafter referred to as the “SA-EL”) is a compact, stand-alone wireless IP (GSM/GPRS/EDGE) modem. The SA-EL is designed for computing devices operating Windows XP and 2000 Professional. Enfora’s SA-EL provides maximum versatility in a single affordable device. 1.2 About this Manual Contained in this manual are instructions on how to install and configure the SAEL modem.
SA-EL User Manual Ver. 1.00 1.3 System Requirements The SA-EL requires the following equipment: • • • • Windows XP or 2000 operating systems. One standard USB port for SA-EL configuration One USB cable to connect the SA-EL to your computer. One standard 2.5 mm cell phone headset for speaker and microphone* *not required for stand alone operation 1.4 Included in the Package The following parts are included in the SA-EL package: • • 1.5 Optional Accessories • • 1.6 Enfora SA-EL modem.
SA-EL User Manual Ver. 1.00 Figure 2 - Rear view of SA-EL modem. 1.7 Regulatory Compliance FCC 1.7.1 FCC The modem was tested and certified to meet FCC Parts 15 in a stand-alone configuration, which demonstrated that the GSM1208 SA-G complies with Part 15 emission limits. FCC Part 22 & Part 24 is covered by the Enfora Enabler-IIG "modular approval" process for a transmitter.
SA-EL User Manual Ver. 1.00 1.7.3 Disclaimer The information and instructions contained within this publication comply with all FCC, GCF, PTCRB, R&TTE, IMEI and other applicable codes that are in effect at the time of publication. Enfora disclaims all responsibility for any act or omissions, or for breach of law, code or regulation, including local or state codes, performed by a third party. Enfora strongly recommends that all installations, hookups, transmissions, etc.
SA-EL User Manual Ver. 1.00 2 Installation 2.1 Subscriber Identity Module (SIM) Card The SIM, an integral part of any GSM terminal device, is a “smart card” that is programmed with subscriber information. The user information consists of an International Mobile Subscriber Identity (IMSI) number, which is registered with the GSM service provider, and an encryption Ki (pronounced “key”). This information consists of a microprocessor and memory installed on a plastic card.
SA-EL User Manual Ver. 1.00 2.2 Connecting the Power Supply The SA-EL modem obtains power via the USB cable that connects the modem to your computer. To supply power to the SA-EL modem, connect the B connector of your USB cable to the connector (labeled "USB") on the modem. Connect the A connector of the USB cable to an USB port on your computer. The user supplies the USB cable. Note: Make sure the SIM card is inserted prior to connecting the USB cable to the SA-EL and your computer.
SA-EL User Manual Ver. 1.00 2.3 Connecting the Antenna The user is responsible for supplying the GSM antenna for the SA-EL modem. The antenna must have a nominal impedance of 50 Ohms. The VSWR must be less than 2.0:1. System antenna gain should be 0-2 dB for optimum performance. See section 1.7 Regulatory Compliance FCC. The SA-EL operates at the 850/900/1800 and 1900 MHz frequency bands.
SA-EL User Manual Ver. 1.00 2.4 Attaching a Microphone/Speaker To place a voice call from the SA-EL, connect a microphone/speaker to the port as shown below in Figure 6. The plug is a standard 2.5mm audio connector. The user must supply the microphone or speaker. Microphone/Audio Port Figure 6 - Microphone/Audio Port on the SA-EL Module EDG1228UG001 8 Version 1.
SA-EL User Manual Ver. 1.00 2.5 LED Functions The SA-EL modem has one LED on the front panel. REG: Indicates GSM network registration status. This LED will flash when attempting to register on a GSM network. The LED will be solid when the modem is registered with a GSM network. 2.6 Mounting the SA-EL The SA-EL includes two mounting options. The modem housing contains four thru holes that can utilize number 2 screws for securing the device.
SA-EL User Manual Ver. 1.00 3 mobile PhoneTools Software The first step in installing mobile PhoneTools software is installing the SA-EL USB drivers. Follow these steps to install the USB drivers. 1. Click on Step 1 – USB Driver Install to install the SA-EL USB driver. DO NOT connect the SA-EL to the computer at this time. 2. Select Install from the application. EDG1228UG001 10 Version 1.
SA-EL User Manual Ver. 1.00 3. The drivers will be installed. You will then be prompted with the Installation Successful window. 4. Select OK to exit the install. 5. Now plug in your SA-EL to the computer USB port. Depending upon the Operating System you are using (Windows XP or Windows 2000) you will see different screens during the installation process. . 3.
SA-EL User Manual Ver. 1.00 Device Manager EDG1228UG001 12 Version 1.
SA-EL User Manual Ver. 1.00 3.2 Windows XP Installation Screens 1. Select Install the software automatically. 2. Click Next. 3. Windows XP will search for the drivers. 4. Windows will finish installing the drivers. Select Finish. EDG1228UG001 13 Version 1.
SA-EL User Manual Ver. 1.00 5. Windows XP might prompt you to install the drivers again. The Hardware Install Wizard may appear again and a pop-up window from the system tray will indicate that Windows has found new hardware. If so, follow Steps 6 through 9 again. 6. When WindowsXP has successfully installed the SA-EL USB drivers a pop-up window from your system tray will state that your hardware is installed and ready to use.
SA-EL User Manual Ver. 1.00 3.3 mobile PhoneTools – Using the Enfora SA-EL Modem The following instructions will explain how to install and configure the Enfora SAEL Modem for use in a computer. All of the instructions and references to a “menu” are specific to the mobile PhoneTools software (not your Operating System). 3.
SA-EL User Manual Ver. 1.00 4. You will see the following InstallShield Wizard screen: 5. Click on Next to continue. 6. You will see the following License Agreement screen: EDG1228UG001 16 Version 1.
SA-EL User Manual Ver. 1.00 7. Click on Yes to continue. You will see the following screen: 8. Click on the radio button marked Complete. 9. Click on Next to continue. You will see the following Setup Status screen: EDG1228UG001 17 Version 1.
SA-EL User Manual Ver. 1.00 10. Once the installation is complete, you will see the following screen which prompts you to configure a Persistent Connection. 11. The Persistent Connection Features are: Start mobile PhoneTools on boot, and Automatic Internet Connection (connection automatically reconnects if dropped). During this step of the setup process you can choose whether or not you would like to install Persistent Connection Features.
SA-EL User Manual Ver. 1.00 12. If you choose to install Persistent Connection Features click on the check mark box. 13. Click Next to continue. You will see the following screen: EDG1228UG001 19 Version 1.
SA-EL User Manual Ver. 1.00 To disable or enable the above features after installation, click on the menu from within mobile PhoneTools, then click on Settings, then the Miscellaneous Tab. 14. Select the Persistent Connection Feature(s) you would like to enable. 15. Click Next to continue. You will see the following screen: Note: For detailed information on Persistent Connection Features, please refer to Section 4 on Page 23. EDG1228UG001 20 Version 1.
SA-EL User Manual Ver. 1.00 16. Click Finish, and allow your computer to restart. Once the mobile PhoneTools software is successfully installed on your computer, you will see this icon on your desktop: Note: For detailed information on Persistent Connection Features, please refer to Section 4 on Page 23. 17. Next, you will see the Phone Detection screen. EDG1228UG001 21 Version 1.
SA-EL User Manual Ver. 1.00 Please wait while your SA-EL modem is being configured by the software. You are now ready to begin using your Enfora SA-EL modem. EDG1228UG001 22 Version 1.
SA-EL User Manual Ver. 1.00 4 Understanding Persistent Connection Features During the installation of mobile PhoneTools, you will have the option of installing the following two Persistent Connection Features: 4.1 Start mobile PhoneTools on boot This feature will automatically start the mobile PhoneTools program every time you start your computer.
SA-EL User Manual Ver. 1.00 4.3 mobile PhoneTools Internet Connection Wizard: There are two ways to create an Internet connection: 1. Select the Globe Icon within mobile PhoneTools. The Internet Connection Wizard will automatically start if there are no existing Internet connections defined. 2. Use the Menu > Setup > Internet connections option. Then, activate Add new Connection.
SA-EL User Manual Ver. 1.00 Use Default Network Settings EDG1228UG001 25 Customize Network Settings Version 1.
SA-EL User Manual Ver. 1.00 EDG1228UG001 26 Version 1.
SA-EL User Manual Ver. 1.00 EDG1228UG001 27 Version 1.
SA-EL User Manual Ver. 1.00 4.4 mobile PhoneTools Button Definitions 4.5 mobile PhoneTools Display Definitions EDG1228UG001 28 Version 1.
SA-EL User Manual Ver. 1.00 4.6 Troubleshooting If you have any questions regarding installation, set up, or operation of the SA-EL, please contact the vendor or distributor from whom you purchased the modem, or your wireless network carrier. http://www.enfora.com EDG1228UG001 29 Version 1.
