System information

The Enfocus Inspector changes accordingly.
3. If necessary, change the Constraint Angle (for SHIFT-shear) or the Cross Hair Color in the
Numeric feedback area of the Enfocus Inspector.
Note: In the Numeric Feedback area you can find exact information about the shearing action
you are about to perform.
4. Do one of the following:
• To shear the object while keeping the center point as the point of origin, drag the object into
a random direction.
• To move the point of origin, double-click on another position inside or outside the object.
Then drag to shear the object using the object’s new point of origin. For example, to create
a parallelogram from a rectangular object, place the point of origin on any of the corners
of the object.
Figure 41: Placing the point of origin on the corners of an object to create a parallelogram from a rectangular
object.
• Hold down the SHIFT key while dragging to limit the shear movement to a fixed angle of
constraint, for example 15°. You can set this angle in the Numeric Feedback category of the
Enfocus Inspector.
Figure 42: Shearing an object in fixed angles, as defined in the Preferences.
• Hold down the ALT key (Windows) or Option key (Macintosh) while dragging to shear a copy
of the selected object.
133
Enfocus PitStop Pro